Easihold Binder for aggregates EASIHOLD MULCH & ROCK BINDER

• Binder for aggregates, water-based and non-toxic resin
• Perfect for securing pebbles and granules on driveways and decorative surfaces
• With Easihold, pebbles immediately receive a protective layer against stains and discoloration. It is a water-based binder and contains no toxic substances
• After applying the liquid, the water evaporates and Easihold does its job. Note: Easihold is not suitable for driveways with vehicle traffic
• It is a water-based product that air-dries. When the water evaporates, the patented Easihold particles bind and stabilize your stones
• It is very important that Easihold is able to complete this evaporation process to achieve its strength
• Warm climate and dry conditions for 48 hours after application will provide optimal performance

HOW TO USE

SPRAY METHOD

Shake the bottle well and ensure the nozzle is set correctly
Apply the first coat to a clean, dry surface, spraying slowly and in a controlled manner to ensure even coverage
After applying the first coat, rake or move the stones to expose any uncoated material
This ensures the surface is sufficiently covered by EASIHOLD
For the second coat, follow the same method as step 2
Once even coverage is achieved, compact the surface to obtain the best adhesion results
Allow to dry for 24 hours
Once the first two coats are dry, apply the third and final finishing coat to the surface. Allow to dry and, if necessary, repeat the application for increased hold

1 COAT = 135 ml/m2
3 COATS = 400 ml/m2

MIXING METHOD

Pour EASIHOLD into a mixing bucket with stones at a ratio of 1:25 by volume
Mix until all material is evenly coated
Pour the mixed material into the desired area
Ensure the area is permeable for complete drainage. Compact the stones or mulch
A flattened and compacted surface will produce the best results

EXAMPLE: Every 5L (5kg) of EASIHOLD allows mixing approximately 125L (188kg) of stones